Mercury Certified Service Dealer on Great Sacandaga Lake

Outboard ServicesMercury Certified Service Logo


This is a list of some of the more common services we perform.  There are many more services available.

Summerize 2-Cycle or 4-Stroke Outboard

  • Battery:  Top off fluid, charge, test, clean terminals, install & connect.
  • Check: engine oil, lower unit oil & trim pump fluid levels.
  • Check charging system.
  • Inspect timing belt.
  • Check for water, oil & fuel leaks.
  • Test run on hose/flusher and check general running condition.
  • Check operation of navigation lights, horn & bilge pump.
  • All minor repairs will be done automatically at an additional charge.  All major repairs will be authorized by ower first.
  • Not all apply to every model.

4-Stroke Outboard Oil & Filter Change

  • Run engine up to operating temperature.
  • Change engine oil & filter and replace drain screw washer.

Change Lower Unit Gear Lube

  • Change gear lube & replace fill and vent screw washers.

Annual 4-Stroke, 2-Cycle, EFI & DFI Outboard Service

  • Check battery condition & clean battery connections.
  • Run Computer Diagnostic scan & check for faults.
  • Remove engine carbon deposits with Power Tune (2-cycle).
  • Inspect bleed lines (2-cycle).
  • Re-build low pressure pump (2-cycle, diaphragm pump; Not VRO).
  • Change gear lube.
  • Change engine oil & filter.
  • Gap & install new spark plugs.
  • Replace fuel filters & water separating fuel filter.
  • Check air &/or fuel rail pressure.
  • Check/adjust valve lash.
  • Check belt.
  • Replace air filter.
  • Check/adjust timing/set-up, sync carbs, check control cable adjustments.
  • Inspect engine wiring.
  • Check anodes.
  • Replace thermostat.
  • Check power trim.
  • Lubricate all fittings.
  • Grease prop shaft and check prop condition.
  • Check engine warning system.
  • Check steering & shifting.
  • Not all apply to every model.

Run Computer Diagnostics

  • Computer diagnostics available for All Mercury products.
  • Computer diagnostics available for Yamaha 4-Strokes, Johnson/Evinrude 4-Strokes by Suzuki, Suzuki 4-Strokes and Honda.

Water Pump Impeller Replacement

  • Remove lower unit, replace impeller with either complete kit or impeller kit as required.
  • Grease driveshaft splines & re-install lower unit.
  • Test run on hose/flusher for proper impeller operation and shifting.
  • NOTE:  Certain model Verado outboards require engine oil to be drained before removing lower unit.  Add Outboard Oil & Filter change for this.